How do you insulate attic in hot climate?

Fiberglass insulation Fiberglass is the most common type of insulation used in homes because it is by far the best, especially for hot climates. Aerosol foam blocks all 3 types of heat. Apply spray foam to the roof covering to bring the attic temperature much closer to room temperature. This allows your air conditioning system to be more efficient and effective.

When applying spray foam to the roof cover, there is no need for attic fans, radiant barriers or additional ventilation grilles. Aerosol insulation, like Owen's new Corning Energy Complete system, uses expandable foam that fills every little nook and cranny to form a complete air barrier. The sprayed foam completely fills the entire cavity, ensuring not only a complete air barrier, but also complete insulation. The Owens Corning system uses blown fiberglass to complete the insulation.

In both cases, good air sealing and a total filling insulating cavity are obtained. For attic insulation in hot climates, blown fiberglass is the best choice. It is fireproof, water resistant and does not settle like insulating paper. Nor does it emit gases such as formaldehyde, as does aerosol insulation foam. Sprayed foam insulation is by far the best type of insulation for hot climates, as it has considerably higher R values than other types of insulation.

The R value of insulation is a rating of how well it does its job. Aerosol foam insulation is highly sought after because it has an incredible R value per inch. This means that on exterior walls that are only 4 inches deep, sprayed foam can provide an effective insulation layer in less space. Best of all, spray foam expands into gaps and crevices that seal air leaks in your home.

While simply adding more insulation to the building doesn't necessarily mean big improvements in efficiency, adding insulation in the right places does. You can talk to a home insulation specialist about what forms of attic insulation are best for improving the energy efficiency of your home. If you're looking for a DIY solution, I suggest you go to Home Depot or Lowes and buy the block insulation you're going to install. Rolled block insulation is one of the most common types of insulation and, in general, what Americans think when they imagine what insulation looks like. I am not against insulating the walls of a house, but it is necessary to properly manage water before pumping a wall with any type of insulation.

Add attic fans and a radiant barrier to mimic aerosol foam and reflect heat, to reduce extremely high attic temperatures. However, your attic will be much colder than if you had only installed insulation in the hot one climate of Austin, Texas. If you're in the Phoenix Valley and looking for insulation contractors to help you with your insulation project, you should consider Barrier Insulation of Phoenix. And most importantly, if instead of spraying foam on roof covers, you are left with enormous benefits if you lose the insulation in the attic floor.

It focuses a large amount of energy (it's a pun intended) on the underside of the roof to keep heat out of the attic and not just the attic floor. Another good practice is to have a continuous layer of insulation by using a layer of rigid insulation to wrap around the entire house. Once you've insulated the lower part of the roof to the maximum, it's time to focus on the attic floor if it's unfinished. Your local insulation contractor will be able to inspect the insulation you already have and make cost-effective recommendations that fit your property, your budget, and your priorities.

There are 4 main categories of insulation available to install in your home or business in hot climates.

Leave Message

Your email address will not be published. Required fields are marked *